Howto setup Raspbian for serial read
This howto will cover the steps to setup a Rasperrypi for reading CSV stream from RPICT series board.
Hardware and OS
This applies to all Raspberrypi.
Tested with OS:
Raspbian Jessie 2017-06-21-raspbian-jessie.img
Raspbian Stretch 2017-09-07-raspbian-stretch-lite.img
Raspbian Stretch 2018-06-27-raspbian-stretch-lite.img
Raspbian Stretch 2018-10-09-raspbian-stretch-lite.img
Raspbian Stretch 2018-11-13-raspbian-stretch-lite.img
If the image from Emoncms (emonpi) is used then this setup is not needed.
Download the image from the raspberrypi website. https://www.raspberrypi.org/downloads/raspbian/
Write the image to the SD card. Follow instructions given by the raspberrypi website.
Once the image written create an empty file called 'ssh' in the boot section of the image.
Power up the raspberrypi and connect it to the ethernet network.
Access the raspberrypi with ssh.
Linux based OS
This is as simple as issuing.
$ ssh pi@raspberrypi
Use password raspberry
On other systems (windows, ios)
We recommend to use the putty tool. Download here
As above use
This will give you access to a terminal window in which you can issue commands on the raspberrypi.
Run the raspi-config tool
$ sudo raspi-config
In the menu expand the Filesystem (optional).
7 Advanced Options A1 Expand Filesystem
Then disable the login uart
5 Interfacing Options P6 Serial
Select No to the login shell question.
Select Yes to the serial port hardware to be enabled question.
Select No to the reboot question (we will do that later).
Update the Raspbian OS.
sudo apt-get update
Edit the /boot/config.txt file
$ sudo nano /boot/config.txt
At the end of the file add the following line:
(note the above will disable bluetooth - if bluetooth is needed do not execute this step and use ttyS0 instead of ttyAMA0 for what follows).
A one liner of the above command would be
sudo bash -c 'echo "dtoverlay=pi3-disable-bt" >> /boot/config.txt'
Save and Exit file.
sudo systemctl disable hciuart
sudo reboot & exit
return to the ssh session again once the raspberrypi up and running again.
Insert the RPICT board on the RPI. Configure and read from serial port
stty -F /dev/ttyAMA0 raw speed 38400 cat /dev/ttyAMA0
[OPTIONAL] It might be useful to get the board with all utilities ready at this point. Just issue the commands below:
sudo apt-get install python-serial wget lechacal.com/RPICT/tools/lcl-rpict-config.py.zip unzip lcl-rpict-config.py.zip