Emonwrt3 Install on OpenWrt: Difference between revisions
Jump to navigation
Jump to search
| (7 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
This is a guide for installing Emonwrt3 software on a fresh OpenWrt Chaos Calmer installation. | |||
This is a guide for installing Emonwrt3 software on a fresh | |||
=Prerequisites= | =Prerequisites= | ||
* OpenWrt is | * OpenWrt is freshly installed with Chaos Calmer version. | ||
* User has both access to the web interface and ssh/telnet. | * User has both access to the web interface and ssh/telnet. | ||
* The unit is connected to the internet to access lechacal.com. | * The unit is connected to the internet to access lechacal.com. | ||
| Line 17: | Line 16: | ||
printf "#::askconsole:/bin/ash --login\n" >> /etc/inittab | printf "#::askconsole:/bin/ash --login\n" >> /etc/inittab | ||
head -n -1 /etc/opkg.conf > /tmp/x; mv /tmp/x /etc/opkg.conf | head -n -1 /etc/opkg.conf > /tmp/x; mv /tmp/x /etc/opkg.conf | ||
printf "src/gz chaos_calmer_lechacal http://lechacal.com/repo/emonwrt3\n#option check_signature 1\n" >>/etc/opkg.conf | printf "src/gz chaos_calmer_lechacal http://lechacal.com/repo/emonwrt3 \n#option check_signature 1\n" >>/etc/opkg.conf | ||
opkg update | opkg update | ||
opkg install emonwrt3 emonwrt3-luci | opkg install emonwrt3 emonwrt3-luci | ||
| Line 24: | Line 23: | ||
reboot & exit | reboot & exit | ||
The web interface now shows the Emonwrt3 tab. | |||
If the Arduino has a different configuration than the web interface then go to '''Emonwrt3''' | '''Channels''' and submit the page has it is shown. | |||
Latest revision as of 16:18, 30 April 2019
This is a guide for installing Emonwrt3 software on a fresh OpenWrt Chaos Calmer installation.
Prerequisites
- OpenWrt is freshly installed with Chaos Calmer version.
- User has both access to the web interface and ssh/telnet.
- The unit is connected to the internet to access lechacal.com.
Installation via command line
Connect to the unit using telnet or ssh. We recommend to use Putty for this purpose.
Then copy paste these commands below in the terminal.
head -n -1 /etc/inittab > /tmp/x; mv /tmp/x /etc/inittab printf "#::askconsole:/bin/ash --login\n" >> /etc/inittab head -n -1 /etc/opkg.conf > /tmp/x; mv /tmp/x /etc/opkg.conf printf "src/gz chaos_calmer_lechacal http://lechacal.com/repo/emonwrt3 \n#option check_signature 1\n" >>/etc/opkg.conf opkg update opkg install emonwrt3 emonwrt3-luci
Then if you do not see any error reboot the unit like so
reboot & exit
The web interface now shows the Emonwrt3 tab.
If the Arduino has a different configuration than the web interface then go to Emonwrt3 | Channels and submit the page has it is shown.