How to program an Attiny85 or Attiny84: Difference between revisions
No edit summary |
|||
| Line 24: | Line 24: | ||
Insert the Attiny85 MCU on the DIP8 socket of the Nanoporg. Beware of the direction when the inserting the MCU. The small dot must be pointed toward the inside of the board. | Insert the Attiny85 MCU on the DIP8 socket of the Nanoporg. Beware of the direction when the inserting the MCU. The small dot must be pointed toward the inside of the board. | ||
==Initial Setup== | |||
For anything below make sure '''Arduino as ISP''' is selected in '''Tools | Programmer''' menu. | For anything below make sure '''Arduino as ISP''' is selected in '''Tools | Programmer''' menu. | ||
==Bootloader== | |||
If programming the MCU for the first time you must burn the bootloader onto it. For this first select the appropriate board in the Arduino IDE. '''Tools | Board | ATtiny85 @ 8Mhz'''. Then select '''Tools | Burn Bootloarder'''. | If programming the MCU for the first time you must burn the bootloader onto it. For this first select the appropriate board in the Arduino IDE. '''Tools | Board | ATtiny85 @ 8Mhz'''. Then select '''Tools | Burn Bootloarder'''. | ||
==Upload Sketch (ATtiny)== | |||
Open your sketch file with the Arduino IDE. Make sure you select the appropriate MCU type in '''Tools | Board'''. Upload the sketch from the IDE. | Open your sketch file with the Arduino IDE. Make sure you select the appropriate MCU type in '''Tools | Board'''. Upload the sketch from the IDE. | ||
Revision as of 09:35, 19 March 2017
Prerequisite
Tiny Core Library
We recommend the tiny core library from this link below.
http://code.google.com/p/arduino-tiny/
Download it and install it in the sketchbook/hardware folder. Follow instructions in the README file for this.
Connect the hardware
For Circuit with ISP port
Connect the NanoProg to the USB port of the computer. Connect the 6 pin ribbon cable to the ISP port of the board to program. Make sure grounds are connected together.
For Attiny85 DIP8
Insert the Attiny85 MCU on the DIP8 socket of the Nanoporg. Beware of the direction when the inserting the MCU. The small dot must be pointed toward the inside of the board.
Initial Setup
For anything below make sure Arduino as ISP is selected in Tools | Programmer menu.
Bootloader
If programming the MCU for the first time you must burn the bootloader onto it. For this first select the appropriate board in the Arduino IDE. Tools | Board | ATtiny85 @ 8Mhz. Then select Tools | Burn Bootloarder.
Upload Sketch (ATtiny)
Open your sketch file with the Arduino IDE. Make sure you select the appropriate MCU type in Tools | Board. Upload the sketch from the IDE.
