RPICT4V3: Difference between revisions
Jump to navigation
Jump to search
| Line 40: | Line 40: | ||
An avr programmer with 6pin ribbon cable is needed for programming. | An avr programmer with 6pin ribbon cable is needed for programming. | ||
There is no jumper to remove to program this board. | |||
Revision as of 13:54, 23 July 2016
- 4 AC current sensor
- 3 AC Voltage sensor.
- Compute real power.
- Fit on Raspberrypi 4 holes mounting pattern.
- Attiny84 Mcu
Recommended sensors
- AC Current sensor: SCT-013-000
- AC Voltage sensor:
- UK: 77DB-06-09
- EU: 77DE-06-09
- US: 77DA-10-09
Files
Emoncms Output
Emonhub Config
[[11]]
nodename = RPICT4V3
firmware = RPICT4V3_V1_1.ino
hardware = RPICT4V3
[[[rx]]]
names = Vrms1,Vrms2,Vrms3,Realpower1,Realpower2,Realpower3,Realpower4
datacodes = h, h, h, h, h, h, h
scales = 1,1,1,1,1,1,1
units = V,V,V,W,W,W,W
Sketch Upload
An avr programmer with 6pin ribbon cable is needed for programming.
There is no jumper to remove to program this board.