RPICT4T4: Difference between revisions

Revision as of 10:57, 8 November 2016

Recommended sensor: SCT-013-000 50mA/100A

Burden Resistor: 24 Ohm

Connector: 3.5mm Jack

Default Voltage for power calculation: 240V (can be modified in firmware).

For AC current only.

Connector: 3.5mm Jack

The intended temperature sensor is the DS18B20 which can be configure in either parasite or normal mode.

The connection to a 3.5mm jack connector is shown below.

NOTE: Raspberrypi must be switched off while connecting and disconnecting the temperature sensor.

Revision as of 23:36, 11 February 2016 (view source) Administrator (talk \| contribs) No edit summary ← Older edit		Revision as of 10:57, 8 November 2016 (view source) Administrator (talk \| contribs) (→‎Files) Newer edit →
Line 26:		Line 26:

	==Files==		==Files==
	[http://lechacal.com/~~7CT1V~~/~~RPICT4T4_v1_1~~.ino Sketch version 1.1]		[http://lechacal.com/4CT4T/RPICT4T4_v1_2.ino Sketch version 1.2]