Update attiny firmware on StepperUNO: Difference between revisions
Jump to navigation
Jump to search
| Line 10: | Line 10: | ||
* stepperUNO 1.5 -> attiny_stepperUNO_v1.4.ino | * stepperUNO 1.5 -> attiny_stepperUNO_v1.4.ino | ||
{| class="wikitable" | |||
|+ | |||
|- | |||
!Library | |||
!Attiny firmware | |||
|- | |||
|stepperUNO 1.4 | |||
|attiny_stepperUNO_v1.2.ino <br>attiny_stepperUNO_v1.3.ino | |||
|- | |||
|stepperUNO 1.4.1 | |||
|attiny_stepperUNO_v1.2.ino <br>attiny_stepperUNO_v1.3.ino | |||
|- | |||
|stepperUNO 1.5.0 | |||
|attiny_stepperUNO_v1.4.ino | |||
|- | |||
|} | |||
=Download= | =Download= | ||
Revision as of 09:54, 28 March 2022
Overview
On the stepperUNO there are 2 attiny microcontrollers. Their purpose is to send the step clock signal to each motor.
Both of them contain a firmware that might be needed to update.
Note that you might have to use the right library version against the version of the attiny84 firmware. See the compatibility table below.
- stepperUNO 1.4 -> attiny_stepperUNO_v1.2.ino or attiny_stepperUNO_v1.3.ino
- stepperUNO 1.5 -> attiny_stepperUNO_v1.4.ino
| Library | Attiny firmware |
|---|---|
| stepperUNO 1.4 | attiny_stepperUNO_v1.2.ino attiny_stepperUNO_v1.3.ino |
| stepperUNO 1.4.1 | attiny_stepperUNO_v1.2.ino attiny_stepperUNO_v1.3.ino |
| stepperUNO 1.5.0 | attiny_stepperUNO_v1.4.ino |
Download
The attiny firmware is an Arduino sketch provided in the library itself.
Open the library zip file then go to the examples folder.
The appropriate attiny sketch is called attiny_stepperUNO_vx.x.ino.
Locate the attiny's
The attiny's are the chips circled on the picture below.
