Tiny Stepper Controller
Arduino Stepper Control Board
The tiny stepper controller is a controller board for stepper motor. It can be controlled manually (potentiometer and switches) and programmed with Arduiono IDE.
Technical Specifications
Stepper Motor driver board: A4988
Microcontroller: Attiny85.
Input Power: 30Volts Maximum.
Power Socket: 2.1mm Jack. Center positive.
Manual Control ready with:
- Potentiometer for speed.
- Push button for single step increment.
- Slider switch for direction selection.
Direction and Step can either be controlled from Attiny85 mcu or from switches.
DIL switch for selection of step resolution.
Two digital I/O available for external use (serial port/external sensors/ external switch/ i2c).
Comes flashed with a basic sketch to run the motor at various speeds. Sketch here.
A short demonstration can be seen on this video
Default Sketch
The default sketch loaded in the Attiny85 is a basic sketch to control the motor manually. The potentiometer will be use as speed control.
Direction will change every turn. However this can be overwritten by changing the jumper on the board.
i2c sketch
The two i2c pins of the Attiny85 are made available on the board to be controlled from a i2c master.