Overview

link to the shop

The NanoFlashProg is an Flash programmer using Arduino Nano.

Currently supported chips are:

Winbond 25Q128FV

This has been particularly designed to flash uboot bootloader on SPI Flash chips.

Hardware

The NanoFlashProg shield fit on an Arduino Nano. The full kit has:

Mini USB port for serial comm.
8 pin connector for connection with socket programmer.

Sketch

Software

A terminal emulator is required to communicate with the programmer. We recommend Cutecom. HyperTerminal or similar will also work as long as the emulator is able to send a file.

Usage

Connect to the programmer using settings 115200 8N1.

On connection the programmer will introduce itself and offer a prompt.

NanoFlashProg v1.0.0
Type h for help
>

Pressing h and enter will show the help.

> h
R - Read page
D - Dump page
W - Write File
I - Chip Info
E - Chip Erase
H - Help
>

Flashing Uboot

We recommend downloading uboot from pepe2k repository. Github link.

You must erase the chip before flashing uboot. At the prompt type e and enter. Then answer y to confirm (or anything else to cancel). This will take around 6 seconds to complete.

> e
Erase Entire Chip? (y/n): y
Erasing chip.
>

Then issue the w command to write a file. The prompt will be waiting for a file. In Cutecom click on Send File. Then select the uboot file downloaded previously.

> w
> Waiting for a file.
Writing page 0
Writing page 1
Writing page 2
...
Writing page 491
Timeout.
>

Once the file has been entirely written to the chip it will timeout and return to the prompt.

You can now check the data in the chip by dumping the first page (a page is 256 bytes). Type d and 1 as for one page.

NanoFlashProg

Contents