Configuration for 3Phase firmware

From lechacal
Jump to navigation Jump to search


The configuration for the 3 Phase firmware inherit mostly from the individual channel firmware documented below.
Over Serial Configuration - Sketch 3.0

This applies for firmware RPICT4V3_3Phase_V5_v1.2.

The 3 Phase firmware allows for computation of three power node at the same time. As opposed to the individual firmware which compute each channel one of after the other.

Only 2 nodes are computed.

  • 1 3Phase node using
    • CT1/V1 for L1
    • CT2/V2 for L2
    • CT3/V3 for L3
  • 1 Current node
    • CT4 as current only
Retrieved from ‘http://lechacal.com//wiki/index.php?title=Configuration_for_3Phase_firmware&oldid=5763’