Configuration for 3Phase firmware

The configuration for the 3 Phase firmware inherit mostly from the individual channel firmware documented below.
Over Serial Configuration - Sketch 3.0

This applies for firmware RPICT4V3_3Phase_V5_v1.2.

The 3 Phase firmware allows for computation of three power node at the same time. As opposed to the individual firmware which compute each channel one of after the other.

Only 2 nodes are computed.

• 1 3Phase node using
  • CT1/V1 for L1
  • CT2/V2 for L2
  • CT3/V3 for L3
• 1 Current node
  • CT4 as current only

This is an example configuration.

[main]
format = 3
nodeid = 11
polling = 5000
kcal = 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 200.42999267578125 200.42999267578125 200.42999267578125 1.0 74.0739974975586 74.0739974975586  74.0739974975586 74.0739974975586
phasecal = 0
vest = 240.000000
xpFREQ = 50
Ncycle = 20
Nnode = 4
Nchan = 6
HWSCT = 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255
HWMCPSCT = 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255
HWVOL = 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255
HWMCPVOL = 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255
CHTYPE = 15 11 16 4 14 7 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255
CHID = 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255 255
debug = 0

HWSCT HWMCPSCT HWVOL HWMCPVOL and CHID are not used. These are normally used by the individual channel firmware.