Emonpi auto reflash

From lechacal
Revision as of 13:22, 10 December 2021 by Administrator (talk | contribs) (Created page with " If you have installed the Emonpi image on your Raspberrypi and have connected the RPICT card on it then there are big chances the RPICT firmware has been wiped out. To confi...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

If you have installed the Emonpi image on your Raspberrypi and have connected the RPICT card on it then there are big chances the RPICT firmware has been wiped out.

To confirm this is the case install the lcl-show-header.py utility with the commands below. 

wget lechacal.com/RPICT/tools/lcl-show-header.py.zip
unzip lcl-show-header.py.zip
sudo mv lcl-show-header.py /usr/local/bin/

Then run it with 

lcl-show-header.py

If the RPICT firmware has been modified you will se the following message.

Retrieved from ‘http://lechacal.com//wiki/index.php?title=Emonpi_auto_reflash&oldid=6033’