RPICT7V1
- 7 AC current sensor
- 1 AC Voltage sensor.
- Compute real power.
- Fit on Raspberrypi 4 holes mounting pattern.
- Attiny84 Mcu
Recommended sensors
- AC Current sensor: SCT-013-000
- AC Voltage sensor:
- UK: 77DB-06-09
- EU: 77DE-06-09
- US: 77DA-10-09
EmonCMS Output
Using the default sketch the output will be Realpower1, Realpower2, Realpower3, Realpower4, Realpower5, Realpower6, Realpower7,Irms1, Irms2, Irms3, Irms4, Irms5, Irms6, Irms7, Vrms
- RealPower in Watts
- Irms in MilliAmps
- Vrms in Volts
Emoncms Config
For default sketch v1.2
[[11]]
nodename = my_RPICT7V1
firmware = v1.2
hardware = RPICT7V1
[[[rx]]]
names = Realpower1, Realpower2, Realpower3, Realpower4, Realpower5, Realpower6, Realpower7,Irms1, Irms2, Irms3, Irms4,Irms5,Irms6,Irms7,Vrms
datacode = h
scales = 1,1,1,1,1,1,1,1,1,1,1,1,1,1,1
units =W,W,W,W,W,W,W,mA,mA,mA,mA,mA,mA,mA,V
Files
Default Sketch V1.2.
SendOnlySoftwareSerial.zip
Sketch Upload
To upload the sketch the three jumper at the center of the board must be removed.
An avr programmer with 6pin ribbon cable is needed for programming.