Difference between revisions of "MODWRT2"
(Created page with " 600px A new version of the MODWRT is under development. See more here MODWRT2. =Modbus RTU to Emoncms Influxdb Thingspeak= Modbus ...")
Revision as of 11:59, 12 August 2019
A new version of the MODWRT is under development. See more here MODWRT2.
Modbus RTU to Emoncms Influxdb Thingspeak
Modbus to Emoncms. The ModWRT is a Modbus RTU unit to interface with one or several RS485 RTU devices. The ModWRT sends a predefined set of registers value to a server for data logging and display.
The end server can be either of type Emoncms, Influxdb or Thingspeak.
All communication and dataflow parameters are configured using a web interface.
- RS485 port
- Ethernet port
- Integrated Wifi
- Micro-usb Power supply
- Operating system: OpenWRT 14.07
- Flash Memory: 64MB
- Dimensions: 90x60x30mm
- Enclosure: Aluminium case
- Optional Wifi antenna
The ModWRT web interface is build within the OpenWRT web interface.
There are three main functional area which are:
1/ RTU's definitions
2/ Servers definitions
3/ Dataflow configuration (ie which data goes where).
The web interface is briefly described below. See more details in the user manual.
1. RTU definition
All Modbus RTU devices can be configured on one single page using Slave ID and communication parameters (baud rate etc).
2. Stream to Emoncms, Influxdb, Thingspeak definition
Internet of Thing (iot) servers can be configured on this page.
3. Dataflow Configuration
Emonwrt3 Network Configuration (same applies for EMonwrt3 and Modwrt).