RPICT3T1: Difference between revisions
No edit summary |
No edit summary |
||
| Line 52: | Line 52: | ||
[[File:IMG_1176_small.png | 200px]] | [[File:IMG_1176_small.png | 200px]] | ||
==Calibration== | |||
If required only ICAL has any effect on the calibration. | |||
VCAL and PHASECAL might be present in the config but have no effect. These should be ignored. | |||
==Emoncms Config (Emonhub)== | ==Emoncms Config (Emonhub)== | ||
Revision as of 13:29, 15 January 2019
This page is for board specific information. More information can be found on the generic page for RPICT series.
Overview
The Rpict3t1 is a small adaptor to measure Power and Temperature.
- 3x AC current sensor
- 1x DS18B20 Temperature Sensor
- Attiny84 Mcu
Notice
Power is computed using estimated Voltage. The estimated voltage can be configured. Default value is 240V.
If power computed using real voltage then use RPICT3V1 board instead. An extra sensor will be required.
Compatibility
| Version | Compatible? |
|---|---|
| Raspberrypi 1 A | Yes |
| Raspberrypi 1 B+ | Yes |
| Raspberrypi 2 B | Yes |
| Raspberrypi 3 B | Yes |
| Raspberrypi 3 B+ | Yes |
Configuration
Starting from sketch version 1.1 the RPICT3T1 is configured over serial.
See general instructions for configuration over serial.
Temperature Sensor
The DS18B20 temperature sensor can be connected directly to the screw terminal connector.
Calibration
If required only ICAL has any effect on the calibration.
VCAL and PHASECAL might be present in the config but have no effect. These should be ignored.
Emoncms Config (Emonhub)
For default configuration. Used as single board only (not stacked).
[[11]]
nodename = RPICT1T1
firmware = RPICT3T1_V1_1.ino
hardware = RPICT3T1
[[[rx]]]
names = Power1,Power2,Power3,Temperature
datacode = 0
scales = 1,1,1,1
units = W,W,W,C
Files
Please verify which board version is yours. This is written on the circuit board itself.
Version 1.3
Default Sketch v1.3
Default Sketch v1.4