RPICT3T1: Difference between revisions
Jump to navigation
Jump to search
(→Files) |
(→Files) |
||
| Line 36: | Line 36: | ||
==Files== | ==Files== | ||
[[File:IMG_1208_small.png | 300px | right]] | |||
[http://www.lechacal.com/RPICT/CT3T1/RPICT3T1_v1_3.ino Default Sketch v1.3]<br> | [http://www.lechacal.com/RPICT/CT3T1/RPICT3T1_v1_3.ino Default Sketch v1.3]<br> | ||
[http://www.lechacal.com/RPICT/CT3T1/RPICT3T1_v1_4.ino Default Sketch v1.4] | [http://www.lechacal.com/RPICT/CT3T1/RPICT3T1_v1_4.ino Default Sketch v1.4] | ||
==Related Pages== | ==Related Pages== | ||
Revision as of 09:05, 19 September 2018
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 3x AC current sensor
- 1x DS18B20 Temperature Sensor
- Attiny84 Mcu
Configuration
Starting from sketch version 1.1 the RPICT3T1 is configured over serial.
See general instructions for configuration over serial.
Temperature Sensor
The DS18B20 temperature sensor can be connected directly to the screw terminal connector.
Emoncms Config (Emonhub)
For default configuration. Used as single board only (not stacked).
[[11]]
nodename = RPICT1T1
firmware = RPICT3T1_V1_1.ino
hardware = RPICT3T1
[[[rx]]]
names = Power1,Power2,Power3,Temperature
datacode = 0
scales = 1,1,1,1
units = W,W,W,C
Files
Default Sketch v1.3
Default Sketch v1.4