RPICT4V3: Difference between revisions
Jump to navigation
Jump to search
(→Files) |
|||
Line 120: | Line 120: | ||
An avr programmer with 6pin ribbon cable is needed for programming. See our programmer called Nanoprog. | An avr programmer with 6pin ribbon cable is needed for programming. See our programmer called Nanoprog. | ||
==Related Link== | ==Related Link== |
Revision as of 13:43, 6 April 2019
Overview
This is RPICT4V3 version 1. This version does not support over serial configuration.
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 4x AC current sensor
- 3x AC Voltage sensor.
- Compute real power.
- Fit on Raspberrypi 4 holes mounting pattern.
- Attiny84 Mcu
Compatibility
Version | Compatible? |
---|---|
Raspberrypi 1 A | Yes |
Raspberrypi 1 B+ | Yes |
Raspberrypi 2 B | Yes |
Raspberrypi 3 B | Yes |
Raspberrypi 3 B+ | Yes |
Recommended sensors
- AC Current sensor: SCT-013-000
- AC Voltage sensor:
- UK: 77DB-06-09
- EU: 77DE-06-09
- US: 77DA-10-09
Files
Power Association
The RPICT4V3 computes RealPower using the combination of Voltage and Current sensor.
The 4 RealPower are computed using the following combinations:
RealPower1 -> CT1 and V1
RealPower2 -> CT2 and V2
RealPower3 -> CT3 and V3
RealPower4 -> CT4 and V3
Emoncms Config (Emonhub)
For default configuration.
[[11]] nodename = RPICT4V3 hardware = RPICT4V3 [[[rx]]] names = Vrms1,Vrms2,Vrms3,Realpower1,Realpower2,Realpower3,Realpower4 datacode = 0 scales = 1,1,1,1,1,1,1 units = V,V,V,W,W,W,W
View the data with Python
Please note the uploaded sketch must have CSV enabled. The example script below will be a good starting point.
First of all make sure you have python-serial package installed
$ sudo apt-get install python-serial
Then copy the following into an executable file and run it.
#!/usr/bin/python import serial ser = serial.Serial('/dev/ttyAMA0', 38400) try: while 1: response = ser.readline() z = response.split(",") if len(z)>=6: print "Vrm1: %s Volts" % z[0] print "Vrm2: %s Volts" % z[1] print "Vrm3: %s Volts" % z[2] print "RealP 1: %s Watts" % z[3] print "RealP 2: %s Watts" % z[4] print "RealP 3: %s Watts" % z[5] print "RealP 4: %s Watts" % z[6][:-2] except KeyboardInterrupt: ser.close()
Sketch Upload
An avr programmer with 6pin ribbon cable is needed for programming. See our programmer called Nanoprog.
Related Link
How to calibrate the Voltage Port