This page is for board specific information. More information can be found on the generic page for RPICT series.

The RPI LCT4V3 has been specifically designed for large CT of 400A and more. CT connector are screw terminal types as opposed to jack connectors.

4 AC current sensor
3 AC Voltage sensor.
Compute real power.
Fit on Raspberrypi 4 holes mounting pattern.
ATmega328 Mcu.
Adapted for 400A CT.

Compatibility


Version	Compatible?
Raspberrypi 1 A	Yes
Raspberrypi 1 B+	Yes
Raspberrypi 2 B	Yes
Raspberrypi 3 B	Yes
Raspberrypi 3 B+	Yes

The RPI_LCT4V3 is not stackable.

Recommended sensors

AC Current sensor: SCT-024
AC Voltage sensor:
- UK: 77DB-06-09
- EU: 77DE-06-09
- US: 77DA-10-09

Configuration

See general instructions for configuration below:

Over Serial Configuration - Sketch 2.8

Over Serial Configuration - Sketch 3.0

The board can be configured with the online configurator.

View the data with Python

Please note the configuration must have Emonhub format enabled (format=3). The example script below will be a good starting point.

First of all make sure you have python-serial package installed

$ sudo apt-get install python-serial

Then copy the following into an executable file and run it.

#!/usr/bin/python
import serial
ser = serial.Serial('/dev/ttyAMA0', 38400)

try:
       while 1:
               response = ser.readline()
               z = response.split(" ")
               if len(z)>=7:
                       print "Vrms 1: %s Volt" % z[1]
                       print "Vrms 2: %s Volt" % z[2]
                       print "Vrms 3: %s Volt" % z[3]
                       print "RealP 1: %s Watt" % z[4]
                       print "RealP 2: %s Watt" % z[5]
                       print "RealP 3: %s Watt" % z[6]
                       print "RealP 4: %s Watt" % z[7][:-2]
except KeyboardInterrupt:
       ser.close()

Emoncms Config (Emonhub)

For default configuration.

 [[11]]
   nodename = my_RPI_LCT4V3
   hardware = RPI_LCT4V3
   [[[rx]]]
      names = Vrms1, Vrms2, Vrms3, RP1, RP2, RP3, RP4
      datacode = 0
      scales = 1,1,1,1,1,1,1
      units = V,V,V,W,W,W,W

Using the default sketch the output will be
NodeID Vrms1 Vrms2 Vrms3 RealPower1 RealPower2 RealPower3 RealPower4