Albawinder: Difference between revisions

From lechacal
Jump to navigation Jump to search
Line 30: Line 30:
<br>
<br>
==CNC Sketch==
==CNC Sketch==
A sketch for controlling the winder via serial port is being developed. This will turn the AlbaWinder into a complete CNC machine. Your contribution is welcome if you wish to help.<br>
Coming Soon. A sketch for controlling the winder via serial port is being developed. This will turn the AlbaWinder into a complete CNC machine. Your contribution is welcome if you wish to help.<br>


=The Control Circuit Board=
=The Control Circuit Board=

Revision as of 10:49, 25 June 2014

Alba Winder - The Arduino Coil Winder

The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components.

Technical Specifications

OpenBeam Frame and components
Dimensions: 40x32x12cm.
2x Nema17 stepper motor.
Rubber cones to adapt a wide range of coils.
2 axis - 1 Carrier axis - 1 Spooling axis.
2 Proximity sensors for detection of the carrier.
Maximum Coil size: Length 25cm Diameter 9cm.


16x2 LCD Display.
1 USB port.
Atmega328 MCU (arduino programmed).
6 push button.
1 potentiometer for speed control.
1 Power switch.

12V operated. Requires 2.1mm Jack center positive.

Sketches (firmware)

Basic sketch

Download the basic sketch here.
This sketch offer the possibility to control the winder with the button provided by the control board. Full instruction to operate the winder with this sketch can be found here.

CNC Sketch

Coming Soon. A sketch for controlling the winder via serial port is being developed. This will turn the AlbaWinder into a complete CNC machine. Your contribution is welcome if you wish to help.

The Control Circuit Board