RPICT4T4

Link to shop

This page is for board specific information. More information can be found on the generic page for RPICT series.

4x AC Current Sensors
4x DS18B20 Temperature Sensors
Attiny84 Mcu

Current Sensor

Recommended sensor: SCT-013-000

Burden Resistor: 24 Ohm

Connector: 3.5mm Jack

Default Voltage for power calculation: 240V (can be modified in firmware).

For AC current only.

Temperature Sensor

Connector: 3.5mm Jack

The intended temperature sensor is the DS18B20 which can be configure in either parasite or normal mode.

The connector is a 3 way screw terminal connector.

Configuration

Starting from sketch version 1.4 the RPICT4T4 is configured over serial.

See general instructions for configuration over serial.

Emoncms Config (Emonhub)

For default configuration.

 [[11]]
   nodename = RPICT4T4
   hardware = RPICT4T4
   [[[rx]]]
       names = Power1, Power2, Power3, Power4, T1, T2, T3, T4
       datacode = 0
       scales = 1,1,1,1,1,1,1,1
       units = W,W,W,W,C,C,C,C

Python Example

Please note the uploaded sketch must have CSV enabled. The example script below will be a good starting point.

First of all make sure you have python-serial package installed

$ sudo apt-get install python-serial

Then copy the following into an executable file and run it.

#!/usr/bin/python
import serial
ser = serial.Serial('/dev/ttyAMA0', 38400)

try:
       while 1:
               response = ser.readline()
               z = response.split(",")
               if len(z)>6:
                       print "Power 1: %s Watts" % z[0]
                       print "Power 2: %s Watts" % z[1]
                       print "Power 3: %s Watts" % z[2]
                       print "Power 4: %s Watts" % z[3]
                       print "Temperature 1: %s C" % z[4]
                       print "Temperature 2: %s C" % z[5]
                       print "Temperature 3: %s C" % z[6]
                       print "Temperature 4: %s C" % z[7][:-2]
except KeyboardInterrupt:
       ser.close()