Difference between revisions of "RPICT and MQTT"

From lechacal
Jump to: navigation, search
(Make the script)
(Make the script)
Line 61: Line 61:
 
  ser.close()
 
  ser.close()
  
Modify the five parameters '''MQTT_SERV''', '''MQTT_PATH''', '''MQTT_USER''', '''MQTT_PASS''' and '''CHANNELS''' to your needs.
+
Modify the five parameters '''MQTT_SERV''', '''MQTT_PATH''', '''MQTT_USER''', '''MQTT_PASS''' and '''CHANNELS''' to your needs. We are using a default RPICT7V1 for our example here.
  
 
Save the file and launch it with the command
 
Save the file and launch it with the command

Revision as of 20:35, 31 May 2019


There are two ways to setup MQTT.
1/ Running a python script.
2/ Using Emonhub.

Using Python Script

In this setup the Raspberrypi where the RPICT is will be the MQTT broker. A script will run to convert the serial string from the RPICT into channel feed.

Setup Mosquito broker

Install Mosquitto using the commands below:

sudo apt install -y mosquitto mosquitto-clients

Enable the service to start at boot time:

sudo systemctl enable mosquitto.service


Make the script

A simple python script can be edited. Create a file with the content of the script below:

MQTT_SERV = "localhost"
MQTT_PATH = "RPICT7V1"
MQTT_USER = ""
MQTT_PASS = ""

CHANNELS = ["NodeID", "RP1", "RP2", "RP3", "RP4", "RP5", "RP6", "RP7",
		"Irms1", "Irms2", "Irms3", "Irms4", "Irms5", "Irms6", "Irms7",
		"Vrms"]

import paho.mqtt.client as mqtt
import serial
ser = serial.Serial('/dev/ttyAMA0', 38400)

client = mqtt.Client("P1")
client.username_pw_set(MQTT_USER, MQTT_PASS)
client.connect(MQTT_SERV)

try:
 	while 1:
 		# Read one line from the serial buffer
		 line = ser.readline()
	 
	 	# Remove the trailing carriage return line feed
	 	line = line[:-2]
	 
	 	# Create an array of the data
	 	Z = line.split(' ')
	 
	 	# Print it for debug
	 	print line
	 
		# Publish to the MQTT broker
 		for i in range(len(Z)):
 			client.publish("%s/%s" % (MQTT_PATH, CHANNELS[i]), Z[i]) 
 
except KeyboardInterrupt:
	client.disconnect()
	ser.close()

Modify the five parameters MQTT_SERV, MQTT_PATH, MQTT_USER, MQTT_PASS and CHANNELS to your needs. We are using a default RPICT7V1 for our example here.

Save the file and launch it with the command

python myfile.py

Using Emonhub