From lechacal
Revision as of 20:38, 31 May 2019 by Administrator (Talk | contribs)

Jump to: navigation, search

There are two ways to setup MQTT.
1/ Running a python script.
2/ Using Emonhub.

Using Python Script

In this setup the Raspberrypi where the RPICT is will be the MQTT broker. A script will run to convert the serial string from the RPICT into channel feed.

Setup Mosquito broker

Install Mosquitto using the commands below:

sudo apt install -y mosquitto mosquitto-clients

Enable the service to start at boot time:

sudo systemctl enable mosquitto.service

Make the script

First of all install the mqtt python module

sudo pip install paho-mqtt

A simple python script can be edited. Create a file with the content of the script below:

MQTT_SERV = "localhost"

CHANNELS = ["NodeID", "RP1", "RP2", "RP3", "RP4", "RP5", "RP6", "RP7",
		"Irms1", "Irms2", "Irms3", "Irms4", "Irms5", "Irms6", "Irms7",

import paho.mqtt.client as mqtt
import serial
ser = serial.Serial('/dev/ttyAMA0', 38400)

client = mqtt.Client("P1")
client.username_pw_set(MQTT_USER, MQTT_PASS)

 	while 1:
 		# Read one line from the serial buffer
		 line = ser.readline()
	 	# Remove the trailing carriage return line feed
	 	line = line[:-2]
	 	# Create an array of the data
	 	Z = line.split(' ')
	 	# Print it for debug
	 	print line
		# Publish to the MQTT broker
 		for i in range(len(Z)):
 			client.publish("%s/%s" % (MQTT_PATH, CHANNELS[i]), Z[i]) 
except KeyboardInterrupt:

Modify the five parameters MQTT_SERV, MQTT_PATH, MQTT_USER, MQTT_PASS and CHANNELS to your needs. We are using a default RPICT7V1 for our example here.

Save the file and launch it with the command

python myfile.py

When running the above script all channels will be published as soon as data are sent by the RPICT board.

Using Emonhub