View source for Before 1st Feb 22 RPICT4W3T1 Configuration

The documentation for serial configuration can be found on this page. <br>
[[Configuration for 3Phase firmware]]<br>


The online configurator can be used with the RPICT4W3T1. Use a single board of RPICT4V3 when editing the configuration.

[[File:Online_config_01.png | 300px| link=http://lechacal.com/RPICT/config/generator/v3.1/]][http://lechacal.com/RPICT/config/generator/v3.1/ Online configurator].

==Data Output==

Using the manufacture firmware the data output is:

 NodeID Vrms1 Vrms2 Vrms3 Realpower1 Realpower2 Realpower3 Irms1 Irms2 Irms3 Irms4 PF1 PF2 PF3 Temperature

Real Powers are computed using the following rules:

RealPower1 -> CT1 & V1<br>
RealPower2 -> CT2 & V2<br>
RealPower3 -> CT3 & V3<br>

These rules can be modified in the configuration if needed.

Other output type can be streamed out. This should be configured in the unit. 

All outputs type available are
* Vrms (V)
* Irms (mA)
* Real Power (W)
* Apparent Power (W)
* Power Factor
* Estimated Power
* Frequency
* Reactive Power
* Temperature