View source for RPICT3V1 Disable channels sketch 2



RPICT3V1 by default outputs all channels. Which are 
 RealPower ApparentPower Irms Vrms PowerFactor

for all 3 Current Voltage pairs computed (ct1 ct2 ct3).

To prevent some of the channels to appear we can disable them by setting the debug variable with a particular number.

===Configure with the web form===

[http://lechacal.com/RPICT/config/generator/rpict3v1_v1.0/ Online Config Generator]

See the [http://lechacal.com/RPICT/config/generator/rpict3v1_v1.0/ Online Config Generator] to get all of this converted from an online form. Read below if you want to understand how this works behind the scene.

===How it works===

debug is coded on 8 bits where each bit correspond to the following (LSB first).<br>

bit 1 - debug; 0 = OFF 1 = ON<br>
bit 2 - Apparent Power; 1 = OFF 0 = ON<br>
bit 3 - Irms; 1 = OFF 0 = ON<br>
bit 4 - Vrms; 1 = OFF 0 = ON<br>
bit 5 - PowerFactor; 1 = OFF 0 = ON<br>
bit 6 - ct3; 1 = OFF 0 = ON<br>
bit 7 - ct2; 1 = OFF 0 = ON<br>
bit 8 - ct1; 1 = OFF 0 = ON<br>

Note that RealPower is always ON and can not be disabled.

* By default alls channels are ON and debug is OFF. 
This is 00000000 in binary and 0 in decimal.
 debug = 0

*To enable debug set bit 1 to 1.
This is 00000001 in binary and 1 in decimal
 debug = 1

* To disable apparent power and enable debug then set bits 1 and 2 to 1
This is 00000011 in binary and 3 in decimal
 debug = 3

* To disable ct2 and ct3 and set debug OFF and bits 6 and 7 to 1.
This is 01100000 in binary and 96 in decimal
 debug = 96

To convert from binary to decimal and back use this [https://www.cs.princeton.edu/courses/archive/fall07/cos109/bc.html webtool here].