RPICT QC Tools: Difference between revisions
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 9: | Line 9: | ||
Download the package | Download the package | ||
wget lechacal.com/RPICT/tools/ | wget lechacal.com/RPICT/tools/rpict-qc-tools.zip | ||
Unzip it | Unzip it | ||
unzip rpict-qc-tools.zip | unzip rpict-qc-tools.zip | ||
| Line 22: | Line 22: | ||
./lcl-qc.py | ./lcl-qc.py | ||
=Revert to original firmware= | |||
[[Upgrading_to_sketch_version_4]] | |||
Latest revision as of 21:24, 18 August 2022
Preliminairies
The guide below must have been followed first.
Upload_Arduino_sketch_from_Raspberrypi_to_RPICT
Installation
Download the package
wget lechacal.com/RPICT/tools/rpict-qc-tools.zip
Unzip it
unzip rpict-qc-tools.zip
Move inside
cd rpict-qc-tools
To read the master board load the firmware below
lcl-upload-sketch.sh QC_01.ino.hex
for the slave load this one instead
lcl-upload-sketch.sh QC_01_slave1.ino.hex
Run it
./lcl-qc.py