Albawinder: Difference between revisions
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components. The | The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components. The | ||
= | =Technical Specifications= | ||
OpenBeam Frame and components | |||
Dimensions: 40x32x12cm. | |||
2x Nema17 stepper motor. | |||
Rubber cones to adapt | Rubber cones to adapt a wide range of coils. | ||
2 axis - 1 Carrier axis - 1 Spooling axis | |||
2 Proximity sensors for detection of the carrier | |||
Maximum Coil size: Length 25cm Diameter 9cm | |||
16x2 LCD Display | |||
1 USB port | |||
Atmega328 MCU (arduino programmed) | |||
6 push button | |||
1 potentiometer for speed control | |||
1 Power switch | |||
12V operated | |||
Revision as of 10:40, 25 June 2014
Alba Winder - The Arduino Coil Winder
The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components. The
Technical Specifications
OpenBeam Frame and components Dimensions: 40x32x12cm. 2x Nema17 stepper motor. Rubber cones to adapt a wide range of coils. 2 axis - 1 Carrier axis - 1 Spooling axis 2 Proximity sensors for detection of the carrier Maximum Coil size: Length 25cm Diameter 9cm
16x2 LCD Display
1 USB port
Atmega328 MCU (arduino programmed)
6 push button
1 potentiometer for speed control
1 Power switch
12V operated