Albawinder: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
=Alba Winder - The Arduino Coil Winder= | =Alba Winder - The Arduino Coil Winder= | ||
The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components. | The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components. | ||
=Technical Specifications= | =Technical Specifications= | ||
Revision as of 10:42, 25 June 2014
Alba Winder - The Arduino Coil Winder
The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components.
Technical Specifications
OpenBeam Frame and components
Dimensions: 40x32x12cm.
2x Nema17 stepper motor.
Rubber cones to adapt a wide range of coils.
2 axis - 1 Carrier axis - 1 Spooling axis.
2 Proximity sensors for detection of the carrier.
Maximum Coil size: Length 25cm Diameter 9cm.
16x2 LCD Display.
1 USB port.
Atmega328 MCU (arduino programmed).
6 push button.
1 potentiometer for speed control.
1 Power switch.
12V operated. Requires 2.1mm Jack center positive.