Albawinder: Difference between revisions
| Line 28: | Line 28: | ||
Download the basic sketch here.<br> | Download the basic sketch here.<br> | ||
This sketch offer the possibility to control the winder with the button provided by the control board.<br> | This sketch offer the possibility to control the winder with the button provided by the control board.<br> | ||
[[Operation | [[Operation Instructions with Basic Sketch]]<br> | ||
<br> | <br> | ||
Revision as of 10:56, 25 June 2014
AlbaWinder - The Arduino Coil Winder
The AlbaWinder is a project developed to create a coil winder controlled by Arduino. It uses OpenBeam frame and components.
Technical Specifications
OpenBeam Frame and components
Dimensions: 40x32x12cm.
2x Nema17 stepper motor.
Rubber cones to adapt a wide range of coils.
2 axis - 1 Carrier axis - 1 Spooling axis.
2 Proximity sensors for detection of the carrier.
Maximum Coil size: Length 25cm Diameter 9cm.
16x2 LCD Display.
1 USB port.
Atmega328 MCU (arduino programmed).
6 push button.
1 potentiometer for speed control.
1 Power switch.
12V operated. Requires 2.1mm Jack center positive.
Sketches (firmware)
Basic sketch
Download the basic sketch here.
This sketch offer the possibility to control the winder with the button provided by the control board.
Operation Instructions with Basic Sketch
CNC Sketch
Coming Soon. A sketch for controlling the winder via serial port is being developed. This will turn the AlbaWinder into a complete CNC machine. Your contribution is welcome if you wish to help.