Update RPICT firmware (CT7V1/CT4V3/CT8): Difference between revisions

Revision as of 12:04, 2 April 2018

Download Sketch

Download the sketch from the dedicated page for the board.

Sketch Upload

Using Nanoprog

One can program the board using the Nanoprog programmer with a 6pin SPI connector.
In Arduino IDE select board as Arduino Uno. Upload sketch using File | Upload Using Programmer.

Using an ArduinoUNO

An Arduino UNO board can be used to program the chip. The micontroller should be removed from the RPICT7V1 board and fitted on the Uno to allow programming.

Erasing EEPROM

If upgrading from a major version change (e.g. 2.4 to 2.5) then an EEPROM erase will be required.

To do this upload the sketch below in the mcu. Then let it run once.

eeprom_erase_v1_0.ino

Revision as of 12:04, 2 April 2018 (view source) Administrator (talk \| contribs) (→‎Erasing EEPROM) ← Older edit		Revision as of 12:04, 2 April 2018 (view source) Administrator (talk \| contribs) (→‎Erasing EEPROM) Newer edit →
Line 21:		Line 21:
	To do this upload the sketch below in the mcu. Then let it run once.		To do this upload the sketch below in the mcu. Then let it run once.

	[[http://lechacal.com/RPICT/tools/eeprom_erase_v1_0.ino eeprom_erase_v1_0.ino]]		[http://lechacal.com/RPICT/tools/eeprom_erase_v1_0.ino eeprom_erase_v1_0.ino]