Revision as of 22:20, 21 January 2019

THIS GUIDE IN INCOMPLETE. COMING SOON...

Overview

We will use the Raspberrypi to collect the ananlog data from the RPICT and serve them as a HTTP server.

This is to demonstrate how a RPICT can be used to display the waveform.

IMPORTANT. This is not a substitute for a scope. This is just a playground for demonstration.

Make sure you have a fresh Raspbian image installed.

Setup the Raspbian to enable the serial port. See the guide below to complete this.
Howto setup Raspbian for serial read

Install lighthttp to configure the Raspberrypi as a web server.

sudo apt-get install lighttpd
sudo wget lechacal.com/repo/emonwrt3/lighttpd.conf -O /etc/lighttpd/lighttpd.conf
sudo /etc/init.d/lighttpd restart

WHAT FOLLOWS IS COMING SOON...

Revision as of 22:19, 21 January 2019 (view source) Administrator (talk \| contribs) (→‎Setup the web server) ← Older edit		Revision as of 22:20, 21 January 2019 (view source) Administrator (talk \| contribs) (→‎Setup the web server) Newer edit →
Line 26:		Line 26:
	sudo /etc/init.d/lighttpd restart		sudo /etc/init.d/lighttpd restart

	COMING SOON...		WHAT FOLLOWS IS COMING SOON...