RPI DCV8: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 19: | Line 19: | ||
The amplification stage can be adapted on the RPI_DCV8 to adjust for desired range. | The amplification stage can be adapted on the RPI_DCV8 to adjust for desired range. | ||
<br> | |||
==AC Current== | ==AC Current== | ||
[[File:269.jpg | 240px | right]] | [[File:269.jpg | 240px | right]] | ||
Revision as of 17:04, 5 November 2019
RPI_DCV8 is a 8 channels acquisition board for Raspberrypi. Any of AC current & voltage or DC current & voltage can be setup at assembly/purchase time.
- 8 Channels (both AC or DC).
- Measure RMS or Average signal.
- Fit on Raspberrypi 4 holes mounting pattern.
- Atmega328p Mcu (Arduino UNO)
- MCP3208 ADC (12bits)
- Screw Terminal connectors.
Channel Setup
DC Current
DC current can be read using a Clamp meter suitable for DC. An example unit is the BT-605A where currents up to 600A can be measured.
The amplification stage can be adapted on the RPI_DCV8 to adjust for desired range.
AC Current
For measuring AC current current a Current Transformer (CT) must be used.
RPI_DCV8 can host the burden resistor for current output CT.