Standalone Arduino Programmer: Difference between revisions
Tag: Manual revert |
|||
| Line 16: | Line 16: | ||
* Provision for use of a small LCD screen. | * Provision for use of a small LCD screen. | ||
= | =Usage= | ||
==Preparing the programmer== | ==Preparing the programmer== | ||
* Compile the target sketch on Arduino IDE. | * Compile the target sketch on Arduino IDE. | ||
| Line 23: | Line 23: | ||
* Rename the file as 'firmware'hex'. | * Rename the file as 'firmware'hex'. | ||
* Insert the SD card in the programmer. | * Insert the SD card in the programmer. | ||
[[File:P1000461.JPG small.png|360px]] | [[File:P1000461.JPG small.png|360px]] | ||
Revision as of 15:09, 7 October 2023
Overview
The standalone Arduino Programmer can programme many atmel chip in stand alone mode which means it does not need a computer to operate. This is very useful for automating the programming of large number of chips.
Features
- Onboard Micro SD card.
- 3 operation LED (work / ok / error).
- 3 operation button.
- 6 pin SPI connection to target.
- Additional GPIO pins available for expansion.
- Provision for use of a small LCD screen.
Usage
Preparing the programmer
- Compile the target sketch on Arduino IDE.
- Locate the produced hex file.
- Copy it to the SD card.
- Rename the file as 'firmware'hex'.
- Insert the SD card in the programmer.
Production Usage
- Connect the 6 pin ribbon cable to the target device.
- Press the OK button.
- Sucessful flash will be indicated with the green led 'ok'
Firmware
Several firmwares that can be used on the programmer.
Factory firmware
The default firmware allow programming with the buttons and confirmation is indicated with leds.
It is loaded in the programmer at factory. Instructions below are here for reference if you need to reflash the programmer.
The firmware can be downloaded from this github repo:.
https://github.com/nickgammon/arduino_sketches
Choose the sketch named Atmega_Hex_Uploader_Fixed_Filename
A special version of SDFat library is needed. Download it from here below. Do not use the latest version of this library or compilation will fail.