RPICT4T4: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 2: | Line 2: | ||
[http://lechacalshop.com/en/internetofthing/15-raspberrypi-4-current-sensor-adaptor-4-temperature-emoncms.html Link to shop] | [http://lechacalshop.com/en/internetofthing/15-raspberrypi-4-current-sensor-adaptor-4-temperature-emoncms.html Link to shop] | ||
This page is for board specific information. More information can be found on the [[Raspberrypi_Current_and_Temperature_Sensor_Adaptor | generic page for RPICT series]]. | |||
* 4x AC Current Sensors | * 4x AC Current Sensors | ||
Revision as of 15:09, 22 March 2017
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 4x AC Current Sensors
- 4x DS18B20 Temperature Sensors
- Attiny84 Mcu
Current Sensor
Recommended sensor: SCT-013-000
Burden Resistor: 24 Ohm
Connector: 3.5mm Jack
Default Voltage for power calculation: 240V (can be modified in firmware).
For AC current only.
Temperature Sensor
Connector: 3.5mm Jack
The intended temperature sensor is the DS18B20 which can be configure in either parasite or normal mode.
The connection to a 3.5mm jack connector is shown below.
NOTE: Raspberrypi must be switched off while connecting and disconnecting the temperature sensor.