Update RPICT firmware (CT7V1/CT4V3/CT8): Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
==Overview== | |||
This page provide information to update the firmware in boards RPICT7V1 version2, RPICT4V3 version2 and RPICT8. | |||
Hardware require is either a Nanoprog or an Arduino UNO. | |||
==Download Sketch== | ==Download Sketch== | ||
Revision as of 12:07, 2 April 2018
Overview
This page provide information to update the firmware in boards RPICT7V1 version2, RPICT4V3 version2 and RPICT8.
Hardware require is either a Nanoprog or an Arduino UNO.
Download Sketch
Download the sketch from the dedicated page for the board.
Erasing EEPROM
If upgrading from a major version change (e.g. 2.4 to 2.5) then an EEPROM erase will be required.
To do this upload the sketch below in the mcu. Then let it run once.
Sketch Upload
Using Nanoprog
One can program the board using the Nanoprog programmer with a 6pin SPI connector.
In Arduino IDE select board as Arduino Uno. Upload sketch using File | Upload Using Programmer.
Using an ArduinoUNO
An Arduino UNO board can be used to program the chip. The micontroller should be removed from the RPICT7V1 board and fitted on the Uno to allow programming.