RPICT4T4

Link to shop

This page is for board specific information. More information can be found on the generic page for RPICT series.

• 4x AC Current Sensors
• 4x DS18B20 Temperature Sensors
• Microcontroller: Atmel ATtiny84

Compatibility

Version	Compatible?
Raspberrypi 1 A	No
Raspberrypi 1 B+	Yes
Raspberrypi 2 B	Yes
Raspberrypi 3 B	Yes
Raspberrypi 3 B+	Yes

Current Sensor

Recommended sensor: SCT-013-000

For AC current only.

Temperature Sensor

Connector: 3.5mm Jack

The intended temperature sensor is the DS18B20.

The connector is a 3 way screw terminal connector.

Configuration

Starting from sketch version 1.4 the RPICT4T4 is configured over serial.

See general instructions for configuration over serial.

Emoncms Config (Emonhub)

For default configuration.

 [[11]]
   nodename = RPICT4T4
   hardware = RPICT4T4
   [[[rx]]]
       names = Power1, Power2, Power3, Power4, T1, T2, T3, T4
       datacode = 0
       scales = 1,1,1,1,1,1,1,1
       units = W,W,W,W,C,C,C,C

Python Example

Please note the uploaded sketch must have CSV enabled. The example script below will be a good starting point.

First of all make sure you have python-serial package installed

$ sudo apt-get install python-serial

Then copy the following into an executable file and run it.

 #!/usr/bin/python2
 import serial
 ser = serial.Serial('/dev/ttyAMA0', 38400)
 
 try:
        while 1:
             # Read one line from the serial buffer
             line = ser.readline()
 
             # Remove the trailing carriage return line feed
             line = line[:-2]
 
             # Create an array of the data
             Z = line.split(' ')
 
             # Print it nicely
             print ("----------")
             for i in range(len(Z)):
                 if i==0:
                     print ("NodeID: %s" % Z[0])
                 elif i in [1,2,3,4]:
                     print ("Power %d: %s W" % (i, Z[i]))
                 else:
                     print ("Temperature %d: %s C" % (i,Z[i]))
                        
 except KeyboardInterrupt:
        ser.close()

Files

Sketch version 1.2

Sketch version 1.3

Sketch version 1.4

Sketch version 1.5

Sketch version 1.6

Related Pages

Howto_setup_Raspbian_for_serial_read

How to program an Attiny85 or Attiny84