RPICT Full Output Firmware: Difference between revisions
Jump to navigation
Jump to search
(Created page with " =Installation= We assume here the Raspberrypi has been prepared with the guide below. Howto_setup_Raspbian_for_serial_read We also assume the packages to flash the Ard...") |
(→Usage) |
||
| Line 19: | Line 19: | ||
=Usage= | =Usage= | ||
When using the lcl-run command produces the following output. | |||
lcl-run | |||
[[File:Fulloutput_002.png]] | |||
[[File:Fulloutput_001.png]] | |||
[[File:Fulloutput_003.png]] | |||
Revision as of 20:30, 17 March 2023
Installation
We assume here the Raspberrypi has been prepared with the guide below.
Howto_setup_Raspbian_for_serial_read
We also assume the packages to flash the Arduino have been setup.
Upload_Arduino_sketch_from_Raspberrypi_to_RPICT
Get the firmware:
wget lechacal.com/RPICT/sketch/RPICT_FULL_OUTPUT_001_v4.1.0.ino.hex
Flash it with:
lcl-upload-sketch.sh RPICT_FULL_OUTPUT_001_v4.1.0.ino.hex
Usage
When using the lcl-run command produces the following output.
lcl-run
