RPICT3T1
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 3x AC current sensor
- 1x DS18B20 Temperature Sensor
- Attiny84 Mcu
Compatibility
| Version | Compatible? |
|---|---|
| Raspberrypi 1 A | Yes |
| Raspberrypi 1 B+ | Yes |
| Raspberrypi 2 B | Yes |
| Raspberrypi 3 B | Yes |
| Raspberrypi 3 B+ | Yes |
Configuration
Starting from sketch version 1.1 the RPICT3T1 is configured over serial.
See general instructions for configuration over serial.
Temperature Sensor
The DS18B20 temperature sensor can be connected directly to the screw terminal connector.
Emoncms Config (Emonhub)
For default configuration. Used as single board only (not stacked).
[[11]]
nodename = RPICT1T1
firmware = RPICT3T1_V1_1.ino
hardware = RPICT3T1
[[[rx]]]
names = Power1,Power2,Power3,Temperature
datacode = 0
scales = 1,1,1,1
units = W,W,W,C
Files
Please verify which board version is yours. This is written on the circuit board itself.
Version 1.3
Default Sketch v1.3
Default Sketch v1.4