Transform a RPICT into a web scope

From lechacal
Revision as of 22:23, 21 January 2019 by Administrator (talk | contribs)
Jump to navigation Jump to search

THIS GUIDE IN INCOMPLETE. COMING SOON...

Overview

This will show the full waveform on a web broser using the RPICT in a special configuration. We will use the Raspberrypi to collect the ananlog data from the RPICT and serve them as a HTTP server.

IMPORTANT. This is not a substitute for a scope. This is just a playground for demonstration.

Preliminaries

Make sure you have a fresh Raspbian image installed.

Setup the Raspbian to enable the serial port. See the guide below to complete this.
Howto setup Raspbian for serial read

Setup the web server

Install lighthttp to configure the Raspberrypi as a web server. 

sudo apt-get install lighttpd
sudo wget lechacal.com/repo/emonwrt3/lighttpd.conf -O /etc/lighttpd/lighttpd.conf
sudo /etc/init.d/lighttpd restart

Upload the Sketch

The RPICT will require a different sketch. Download the appropriate sketch that applies to your board.

RPICT4T4 RPICT3V1 RPICT3T1

RPICT7V1 RPICT4V3 RPICT8


WHAT FOLLOWS IS COMING SOON...

Retrieved from ‘http://lechacal.com//wiki/index.php?title=Transform_a_RPICT_into_a_web_scope&oldid=3172’