THIS GUIDE IN INCOMPLETE. COMING SOON...

Overview

We will use the Raspberrypi to collect the ananlog data from the RPICT and serve them as a HTTP server.

This is to demonstrate how a RPICT can be used to display the waveform.

IMPORTANT. This is not a substitute for a scope. This is just a playground for demonstration.

Preliminaries

Make sure you have a fresh Raspbian image installed.

Setup the Raspbian to enable the serial port. See the guide below to complete this.
Howto setup Raspbian for serial read

Install lighthttp to configure the Raspberrypi as a web server.

sudo apt-get install lighttpd
sudo wget lechacal.com/repo/emonwrt3/lighttpd.conf -O /etc/lighttpd/lighttpd.conf
sudo /etc/init.d/lighttpd restart

COMING SOON...