Upgrading to sketch version 4

From lechacal
Jump to navigation Jump to search


There is now a new release of the default factory sketch. This is version 4.0.0.

Current product are still being sold with the previous 3.2.0 version therefore you should manually install this one if you want to upgrade.

This is for all units RPICT8 RPICT7V1 RPICT4V3 RPIZ_CT4V3T2 all in version 3 4 and 5.

RPICT3T1 and RPICT3V1 and equivalent for raspberrypi zero are not concerned by this upgrade.

What's new?

Version 4 has been through a complete review and allow for multiple type of computation nodes within the same RPICT unit.

The major improvement is the support of a new web interface. This is still under development and for now only support a basic configuration. Later we will have a more advanced with full control of node configuration.

Installation

Sketch

Install avrdude on the Raspberrypi. For this just follow the steps in the guide below.
Upload Arduino sketch from Raspberrypi to RPICT

Download the new frimware. For version 3: 

wget lechacal.com/RPICT/sketch/RPICT_MCP3208_V3_v4.0.0.ino

For version 4 and 5: 

wget lechacal.com/RPICT/sketch/RPICT_MCP3208_v4.0.0.ino

Then upload the firmware to the RPICT unit using 

lcl-upload-sketch.sh RPICT_MCP3208_v4.0.0.ino

Lcl-rpict Package

We have packed together the web interface with all the tools required in a single package.

Get the package: 

wget lechacal.com/RPICT/tools/lcl-rpict-package_v1.0.0.deb

Install it with 

sudo dkpg -i lcl-rpict-package_v1.0.0.deb
Retrieved from ‘http://lechacal.com//wiki/index.php?title=Upgrading_to_sketch_version_4&oldid=5985’