RPICT3T1: Difference between revisions
Jump to navigation
Jump to search
(→Files) |
|||
Line 71: | Line 71: | ||
[[Use Emonhub with RPICT]] | [[Use Emonhub with RPICT]] | ||
[[ | [[Howto_setup_Raspbian_for_serial_read]] | ||
[[How to program an Attiny85 or Attiny84]] | [[How to program an Attiny85 or Attiny84]] |
Revision as of 16:46, 19 December 2018
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 3x AC current sensor
- 1x DS18B20 Temperature Sensor
- Attiny84 Mcu
Compatibility
Version | Compatible? |
---|---|
Raspberrypi 1 A | Yes |
Raspberrypi 1 B+ | Yes |
Raspberrypi 2 B | Yes |
Raspberrypi 3 B | Yes |
Raspberrypi 3 B+ | Yes |
Configuration
Starting from sketch version 1.1 the RPICT3T1 is configured over serial.
See general instructions for configuration over serial.
Temperature Sensor
The DS18B20 temperature sensor can be connected directly to the screw terminal connector.
Emoncms Config (Emonhub)
For default configuration. Used as single board only (not stacked).
[[11]] nodename = RPICT1T1 firmware = RPICT3T1_V1_1.ino hardware = RPICT3T1 [[[rx]]] names = Power1,Power2,Power3,Temperature datacode = 0 scales = 1,1,1,1 units = W,W,W,C
Files
Please verify which board version is yours. This is written on the circuit board itself.
Version 1.3
Default Sketch v1.3
Default Sketch v1.4