RPI T8: Difference between revisions
Jump to navigation
Jump to search
| Line 46: | Line 46: | ||
[[File:IMG_1907_small.png | 300px]] [[File:IMG_1910_small.png | 300px]] | [[File:IMG_1907_small.png | 300px]] [[File:IMG_1910_small.png | 300px]] | ||
=Stacking Information= | |||
The RPI_T8 can be used on its own or stacked on top of RPICT7V1 RPICT4V3 or RPICT8. | |||
The RPI_T8 must be slave 1. i.e. First jumper set as slave. | |||
RPI_T8 must be the top unit in any stack. This is due to the screw terminal which won't be available if not at the top. | |||
[[File:IMG_1911_small.png | 300px]] [[File:IMG_1912_small.png | 300px]] | [[File:IMG_1911_small.png | 300px]] [[File:IMG_1912_small.png | 300px]] | ||
Revision as of 18:48, 7 April 2019
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 8 Temperature ports
- Fit on Raspberrypi 4 holes mounting pattern.
- AtMega328 Mcu (Arduino UNO)
- Stackable
Compatibility
| Version | Compatible? |
|---|---|
| Raspberrypi 1 A | No |
| Raspberrypi 1 B+ | Yes |
| Raspberrypi 2 B | Yes |
| Raspberrypi 3 B | Yes |
| Raspberrypi 3 B+ | Partially (Contact shop if required) More info here. |
Recommended sensors
- DS18B20
Stacking Information
The RPI_T8 can be used on its own or stacked on top of RPICT7V1 RPICT4V3 or RPICT8.
The RPI_T8 must be slave 1. i.e. First jumper set as slave.
RPI_T8 must be the top unit in any stack. This is due to the screw terminal which won't be available if not at the top.
