Revision as of 21:58, 3 March 2022

Overview

This is to show the waveform on a web browser using the RPICT in a special configuration. We will use the Raspberrypi to collect the analogue data from the RPICT and serve them as a HTTP server.

IMPORTANT. This is not a substitute for a scope. This is just a playground for demonstration.

Preliminaries

Make sure you have a fresh Raspbian image installed.

Setup the Raspbian to enable the serial port. See the guide below to complete this.
Howto setup Raspbian for serial read

Upload the Sketch

The RPICT will require a different sketch depending on the model. Download the appropriate sketch that applies.

RPICT4T4 RPICT3V1

RPICT Scope Attiny Version 1.0

RPICT3T1

coming soon.

RPICT7V1 RPICT4V3 RPICT8

Prepare the Raspberrypi for uploading new firmwares. Follow the instructions in the guide below.

Upload Arduino sketch from Raspberrypi to RPICT

Get the scope sketch.

wget lechacal.com/RPICT/sketch/RPICT_SCOPE_MCP3208_v1_4.ino.hex

Upload it to the RPICT unit.

lcl-upload-sketch.sh RPICT_SCOPE_MCP3208_v1_4.ino.hex

Setup the web server

Navigate to the http public folder and install the scope webserver.

cd /var/www/html/
sudo wget lechacal.com/RPICT/scope/rpict-scope-v1.0.zip
sudo unzip rpict-scope-v1.0.zip

Now start a server instance

cd /var/www/html/
python3 -m http.server 8000

This will create a folder called scope. There is a configuration file inside called rpict-scope.conf which should not need to be modified.

Run the service and view the data

From the raspberrypi run the following command.

cd /var/www/html/scope/
sudo ./lcl-rpict-scope.py

Then now open a web browser and go to address

http://raspberrypi/scope/scope.html?yrange=4100

Modify yrange in the address as required.

@@ Line 41: / Line 41: @@
 =Setup the web server=
-Install lighthttp to configure the Raspberrypi as a web server.
+Navigate to the http public folder and install the scope webserver.
- sudo apt-get install lighttpd
- sudo wget lechacal.com/repo/emonwrt3/lighttpd.conf -O /tmp/lighttpd.conf
-Make sure the previous command is successful before entering the following one.
- sudo cp /tmp/lighttpd.conf /etc/lighttpd/lighttpd.conf
-Now navigate to the http public folder and install the scope webserver.
   cd /var/www/html/
@@ Line 55: / Line 47: @@
   sudo unzip rpict-scope-v1.0.zip
-This will create a folder called ''scope''. There is a configuration file inside called ''rpict-scope.conf'' which should not need to be modified.
+Now start a server instance
-At time of writing lighttpd need a small fix. The 2 commands below are for this.
+  cd /var/www/html/
-  cd /usr/share/lighttpd
+  python3 -m http.server 8000
-  sudo ln -s create-mime.conf.pl create-mime.assign.pl
-Restart the service using
+This will create a folder called ''scope''. There is a configuration file inside called ''rpict-scope.conf'' which should not need to be modified.
- sudo /etc/init.d/lighttpd restart
 =Run the service and view the data=

Transform a RPICT into a web scope: Difference between revisions