RPI T8
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 8 Temperature ports
- Fit on Raspberrypi 4 holes mounting pattern.
- AtMega328 Mcu (Arduino UNO)
- Stackable
Compatibility
| Version | Compatible? |
|---|---|
| Raspberrypi 1 A | No |
| Raspberrypi 1 B+ | Yes |
| Raspberrypi 2 B | Yes |
| Raspberrypi 3 B | Yes |
| Raspberrypi 3 B+ | Partially (Contact shop if required) More info here. |
Recommended sensors
- DS18B20
Stacking Information
The RPI_T8 can be used on its own or stacked on top of RPICT7V1 RPICT4V3 or RPICT8.
The RPI_T8 must be slave 1. i.e. First jumper set as slave. Microcontroller must be removed from the board to operate as slave.
RPI_T8 must be the top unit in any stack. This is due to the screw terminal which won't be available if not at the top.
General stacking information is described in the RPICT stacking page.
RPICT_Stacking
Files
Sketch
Master Sketch
coming soon...
Slave Sketch
In order to use the RPI_T8 as slave the master board must be flashed with the sketch below with temperature support enabled. To enable Temperature support uncomment line 10 in the sketch. Remove the two slashes in the following line.
//#define TEMPERATURE_SUPPORT